Detail 01
20.5 x 15.5 x 7.5 inch interior
Measure your gear including knobs and connectors. Foam eats roughly an inch on every side once fitted.

Independent shopping perspective
Waterproof injection-molded case with cubed pluck foam, sized for small gear. For anyone moving pedals, mics, or tools who needs real protection over convenience.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Measure your gear including knobs and connectors. Foam eats roughly an inch on every side once fitted.
Detail 02
You tear out cubes by hand to shape a cavity. No cutting tools needed, but the fit is permanent once plucked.
Detail 03
Most of the depth sits in the base. Tall gear should load into the base, not straddle the hinge line.
Detail 04
Sealed gasket keeps water and dust out during transport. It rides in the rain or in a trailer without wrapping.
Detail 05
The shell holds shape in a freezing truck or a hot parking lot. Your gear inside may not tolerate the same range.
Detail 06
Small enough to check as luggage or hand-carry, so freight cost stays low compared to a full trunk case.
Final check

Product questions
Straight answers to the questions shoppers most often ask about this product.
Only a small one. Usable floor is 20.5 by 15.5 inches before foam, which fits a compact board of four to six pedals, not a full-size board.
Yes. It ships with cubed pluck foam that you shape by pulling out cubes to match your gear.
It carries a waterproof military standard rating with a sealed gasket, so it keeps out water and dust during transport.
7.5 inches total: 5.5 in the base and 2 in the lid. Foam layers reduce that further, so plan for about 6 inches of usable clearance.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.