Detail 01
Active circuit
Needs a 9V battery and a stereo output jack to switch the circuit on and off when you unplug.

Independent shopping perspective
An active neck-position humbucker from Seymour Duncan's Zephyr line, in black. A pickup swap for players chasing a clean, high-output neck voice.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Needs a 9V battery and a stereo output jack to switch the circuit on and off when you unplug.
Detail 02
Wound and voiced for the neck slot; putting it at the bridge will sound thick and undefined.
Detail 03
Two coils cancel hum, so it stays quiet under stage lighting and near computer screens.
Detail 04
Matches black hardware; a covered bucker reads slightly smoother on top end than an open coil.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes. Active pickups require a 9V battery and a stereo output jack, which grounds the circuit only when a cable is plugged in.
Not cleanly. Output levels and pot values differ, so you get a big volume mismatch. Run actives in both positions or neither.
It needs a standard humbucker route in the neck position, plus room for a battery. Measure your cavity and check for a battery compartment.
Only if you are comfortable soldering and wiring a stereo jack. Otherwise a tech handles it in under an hour.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.