Detail 01
High-output winding
Hits the amp harder, so you reach distortion earlier and with less pedal gain in front.
Product detailSKU #1274034493477
Seymour DuncanDuncan Distortion Humbucker Pickup Red Neck
1/4
Independent shopping perspective
The Korena take
A high-output humbucker for the neck position, built for players who want thick sustain and clarity under heavy distortion rather than clean sparkle.
Strong match
Who this is for
- Neck-position leads that need to stay defined under high gain
- Hard rock and metal rhythm players wanting a thicker neck voice
- Replacing a muddy stock neck humbucker
Consider the trade-offs
When to look elsewhere
- Jazz and blues players wanting a warm, low-output neck tone
- Clean-only rigs — high output pushes an amp front end early
- Guitars with single-coil routes only
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Neck position version
Wound differently from the bridge model so it doesn't overpower the bridge pickup when you switch.
Detail 03
Humbucker construction
Two coils cancel hum, which matters most at the gain levels this pickup is built for.
Detail 04
Red bobbins
An open-coil look — visible through the pickup ring, so it changes the guitar's appearance.
Detail 05
Full-size humbucker footprint
Needs an existing humbucker route; it will not drop into a single-coil slot.
Final check
Know before you order
- 01Pickup only — no rings, pots, switch, or hardware included
- 02Requires soldering and often re-balancing pickup height afterward
- 03Pairs best with a bridge pickup of similar output to keep switching even
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Is this the same as the bridge Duncan Distortion?
No. This is the neck version, wound lower so it balances against a hot bridge pickup instead of overwhelming it.
02Will it fit my Les Paul?
It's a standard full-size humbucker, so it fits a normal humbucker route and mounting ring.
03Does it clean up at all?
It responds to your volume knob, but high-output pickups stay thicker and darker when rolled back than vintage-output ones.
04What does it cost to install?
The pickup is $99. Shop installation is extra and varies; simple swaps are usually under an hour of labor.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Red
