Detail 01
2R sizing
Ligature sizes track mouthpiece body diameter. 2R covers most hard rubber tenor pieces, not the slimmer metal ones.
Product detailSKU #1274228066741
RovnerDark Tenor Saxophone Ligature and Cap 2R -Fits Most Rubber Tenor Sax Mouthpieces
1/2
Independent shopping perspective
The Korena take
A tenor sax ligature with matching cap, size 2R for hard rubber mouthpieces. For players replacing a stock ligature that slips or bites.
Strong match
Who this is for
- Tenor players on a hard rubber mouthpiece needing a better clamp
- Replacing a bent or stripped ligature that came with the horn
- Anyone who wants a cap included rather than bought separately
Consider the trade-offs
When to look elsewhere
- Metal tenor mouthpieces — the 2R size is cut for rubber
- Alto or soprano mouthpieces, which need their own size
- Players wanting a bright, edgy setup
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Fits most rubber mouthpieces
Measure or test-fit an unusual mouthpiece. Too loose and the reed shifts; too tight and it won't close.
Detail 03
Cap included
Protects the reed tip in the case. Caps are sized to the ligature, so a mismatched one won't seat.
Detail 04
'Dark' voicing
This is the mellower end of Rovner's range — fuller and rounder rather than bright and cutting.
Detail 05
Ligature's job
It holds the reed flat against the table. Uneven clamping is what causes stuffy response and dead low notes.
Final check
Know before you order
- 01Confirm your mouthpiece is hard rubber, not metal, before ordering this size
- 02No reed or mouthpiece included — this is the ligature and cap only
- 03Snug the screw only until the reed stops moving; overtightening chokes the tone
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this fit a metal tenor mouthpiece?
No. 2R is sized for hard rubber tenor mouthpieces. Metal pieces have a narrower body and need a different size.
02Does it come with a cap?
Yes. The cap is included and sized to this ligature.
03Which way does the ligature go on?
Slide it over the mouthpiece before the reed, position it so it clamps below the reed's cut, then tighten just enough to hold.
04Will it fit my alto mouthpiece?
No. This is a tenor size. Alto mouthpieces are smaller and need an alto ligature.
