Detail 01
13-pin connector
Carries six separate string signals plus normal guitar output and control data over one cable. Both ends must be 13-pin.

Independent shopping perspective
The 13-pin cable that connects a GK-equipped guitar or divided pickup to a Roland guitar synth or modeling unit. Buy it if you have that gear.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Carries six separate string signals plus normal guitar output and control data over one cable. Both ends must be 13-pin.
Detail 02
Enough to stand comfortably from a floor unit. Long enough for a small stage; coil the slack rather than stretch it.
Detail 03
The connector screws down at each end, so a foot snag pulls the cable, not the pins, out of alignment.
Detail 04
Disappears on a dark stage and against a black pedalboard, which matters when it is the thickest cable in the run.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes. The GK-3 uses a 13-pin output, and this is the matching 13-pin cable. Screw the collar down at both ends.
No. The connector is 13-pin, not 1/4 in, so it will not plug into a normal amp or pedal input.
For most small and mid-size stages, yes. If you roam wide or the unit sits in a rack offstage, look for a longer run.
At 15 ft, no meaningful loss. Problems in 13-pin rigs usually trace to a damaged connector or loose collar rather than length.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.