Detail 01
Pad clamp
Attaches a pad to a tube; the tube and pad are separate purchases.
Product detailSKU #1274034491862
RolandAPC-33 Drum Pad Clamp
1/2
Independent shopping perspective
The Korena take
A clamp for mounting a Roland drum pad to a rack tube or stand. A hardware part, bought to expand or rearrange an existing kit.
Strong match
Who this is for
- Adding an extra pad or cymbal to a rack you already own
- Replacing a stripped or seized clamp on an electronic kit
- Repositioning pads when a stock mount will not reach
Consider the trade-offs
When to look elsewhere
- Anyone expecting a pad or stand in the box
- Acoustic drum hardware, which uses different mounting sizes
- Players who need a full stand rather than a single clamp
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Roland-spec mount
Sized around Roland rack tubing and pad mounts, so fit on other brands is not a given.
Detail 03
Wing-bolt tension
Position can be reset by hand between songs without pulling out a drum key.
Detail 04
Single-clamp part
One mounting point only — a second pad needs a second clamp.
Final check
Know before you order
- 01Clamp only. No pad, arm, rack tube, or cable is included.
- 02Measure your rack tube diameter before ordering; clamps are size-specific.
- 03Hard playing loosens any clamp — retighten after the first few sessions.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does a pad come with it?
No. This is the mounting clamp on its own. The pad and the rack or stand are separate.
02Will it fit a non-Roland rack?
It is built around Roland rack tubing. Other brands may match, but check the tube diameter before buying.
03Can I mount a cymbal pad with it?
It is a drum pad clamp. Cymbal pads use their own arm hardware, so check your pad's mount before assuming a fit.
04Do I need tools to install it?
The tensioning is done by hand with the bolt. No drum key or wrench is needed for normal adjustment.
