Detail 01
Powerstroke 3 design
An underlay ring at the edge kills overtones at the source, so you need less internal muffling.

Independent shopping perspective
An 18-inch bass drum head with a Fiberskyn surface and built-in edge dampening. For bop and small-kit players chasing a dry, vintage thump.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
An underlay ring at the edge kills overtones at the source, so you need less internal muffling.
Detail 02
Textured synthetic with a calfskin look and a darker, softer attack than a plain coated head.
Detail 03
Thinner ply responds to lighter foot technique and gives more tone, less pure smack.
Detail 04
Matches an 18-inch bass drum shell diameter, not the hoop measurement. Measure the shell if unsure.
Detail 05
Just the head. Your existing bass drum hoop, claws and T-rods get reused.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It is built as a batter head. The dampening ring and Fiberskyn surface are meant to take beater contact.
Usually less of one. The edge ring already shortens the note. Start with no muffling and add a small towel only if it rings too long.
No. Drum heads are sized to the shell diameter. An 18-inch head only fits an 18-inch bass drum.
No. Buy an impact patch separately, especially with a hard beater, or the film wears through at the strike point.