Detail 01
Snare side
Extremely thin film built to vibrate against the snare wires. It will tear quickly if struck with a stick.
Product detailSKU #1274034491180
RemoAmbassador Clear Snare Side Marching Head 14 in.
Sale
Independent shopping perspective
The Korena take
Thin clear 14" snare-side head for marching snares. The bottom head that lets the snare wires speak. Replacement part, not an upgrade.
Strong match
Who this is for
- Replacing a torn or dead snare-side head on a marching snare
- Drum lines needing a consistent, standard bottom head
- Restoring snare response that has gone dull and slow
Consider the trade-offs
When to look elsewhere
- Anyone needing a batter head — this cannot take stick strikes
- Kit snares wanting maximum sustain from a thicker bottom head
- Drums measuring 13" or 15" across
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Ambassador weight
Remo's standard thickness — the baseline response most drummers compare other snare-side heads against.
Detail 03
Clear film
No coating, so nothing damps the film. Maximum sensitivity and a crisp, immediate snare response.
Detail 04
Marching head
Built for the higher tensions marching snares run, where a standard kit snare-side head is more likely to fail.
Detail 05
14 in.
Fits 14" snare shells. Measure the drum's diameter, not the outer hoop.
Final check
Know before you order
- 01Loosen the snare wires fully before removing the old head or you will tear this one
- 02Tension evenly in small increments — thin film splits fast if pulled unevenly
- 03One head only; batter head and snare wires are separate
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use this as a top head?
No. Snare-side film is a fraction of the thickness of a batter head. A few normal strikes will split it.
02How tight should it be?
Snare-side heads run tighter than batter heads. Go up in small even turns around the drum and stop when the snare response gets crisp and quick.
03Will it fit a regular drum set snare?
It fits any 14" snare. It is built for marching tensions, so on a kit snare tuned lower you may not notice the difference from a standard snare-side head.
04Why did my old one tear?
Usually a stray rimshot, a dented hoop edge, or uneven tensioning. Snare wires left tight during a head change also cut the film.
