Detail 01
S-style bridge fit
Cut for Strat-type six-saddle bridges. Other bridge families use different saddle footprints and will not accept these.
Product detailSKU #1292606661817
ProlineS-Style Bridge Saddle Set W/Spring & Screw Chrome
Independent shopping perspective
The Korena take
A chrome saddle set with springs and screws for Strat-style bridges. For replacing worn, rusted, or buzzing saddles on a bolt-on electric.
Strong match
Who this is for
- Replacing pitted saddles that are eating strings at the break point
- Fixing seized or stripped intonation hardware on an older bridge
- Restoring a bridge after rust from sweat or a damp case
Consider the trade-offs
When to look elsewhere
- Tune-o-matic, hardtail block, or Floyd-style bridges
- Players who need a specific string spacing without measuring first
- Anyone chasing a tone change rather than a hardware repair
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Springs included
Intonation springs fatigue and rust. Fresh ones hold saddle position instead of letting it creep under string tension.
Detail 03
Screws included
You get the intonation hardware, so stripped or seized screws come out of the equation in the same job.
Detail 04
Chrome finish
Bright, hard-wearing plating that matches most stock Strat-style bridges, tuners, and jack plates.
Detail 05
Full set, not singles
All saddles wear together. Replacing the set keeps height and radius consistent instead of mixing old and new.
Final check
Know before you order
- 01Measure your bridge string spacing. Saddle width has to match or strings sit off the neck
- 02Height adjustment screws may not be included, so keep your originals
- 03Plan to reset intonation and saddle height afterward. A tuner is required
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will these fit my Strat?
They are made for Strat-style six-saddle bridges. Measure your current saddle width and the bridge plate slots first, since spacing varies between makers and eras.
02Do I need to re-intonate after installing these?
Yes. Saddle position resets when you swap them. Set string height first, then intonate each string with a tuner at the 12th fret.
03What comes in the set?
Saddles with springs and screws. Anything else on your bridge, including height screws and the block, stays as is.
04Is this a tone upgrade?
Treat it as a repair part. Buy it when saddles are pitted, rusted, buzzing, or the intonation screws are seized.
