Detail 01
35 lb maximum load
This is the real limiting spec. Weigh your keyboard first. Most hammer-action 88s land well past this.
Product detailSKU #1273887983360
ProlinePL100 X-Braced Keyboard Stand
Independent shopping perspective
The Korena take
Single-tier X-braced keyboard stand rated to 35 lb. For lighter synths, controllers, and 61-key boards, not weighted 88s.
Strong match
Who this is for
- 61-key synths and MIDI controllers under 35 lb
- Players who set up and tear down often
- Practice rooms where the stand adjusts between users
Consider the trade-offs
When to look elsewhere
- Weighted 88-key boards, which usually exceed 35 lb
- Anyone stacking a second keyboard on top
- Players needing a stand above 37 inches
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
27 to 37 inch height range
Covers seated playing at the low end and standing at the top. Tall players may want more than 37 inches.
Detail 03
Fully welded contact points
Joints are welded rather than bolted, so they will not loosen and rattle over repeated setups.
Detail 04
X-braced design
Raising the stand narrows the arm spread. A wide board may need the stand lower than you expect.
Detail 05
Rubber adjustable feet
Feet adjust for uneven stage floors and grip so the stand does not walk while you play.
Final check
Know before you order
- 01Check your keyboard's weight against the 35 lb limit
- 02Measure board width against arm spread at your playing height
- 03No sustain pedal or keyboard included
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will it hold an 88-key digital piano?
Only if that piano weighs under 35 lb. Most hammer-action 88-key boards are heavier, so check the weight before ordering.
02How tall does it go?
37 inches at the top setting, 27 inches at the lowest. That covers seated playing through most standing positions.
03Does it wobble?
The X-brace uses fully welded contact points, so there are no bolted joints to loosen. Set all feet flat on the floor for the steadiest result.
04Can I add a second tier later?
This is a single-tier stand. For two keyboards, start with a two-tier model rather than adding to this one.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Material
- Metal
1 detailsSize & weight
- Height Adjustment
- 27 inch-37 inch
7 detailsOther
- Product Type
- Keyboard stand
- Adjustable Feet
- Rubber
- Maximum Load
- 35 lb.
- Design
- X-braced
- Contact Points
- Fully welded
- Model
- PL100
- Stability
- Wobble-free
