Detail 01
1 ft length
This is a patch tail, not a run. Both destinations must sit within about a foot.
Product detailSKU #1274034489637
ProCoYMXF2XM-1 Y Mic Female XLR to 2-Male XLR Cable - 1 Ft
Independent shopping perspective
The Korena take
One-foot Y cable splitting a single female XLR into two male XLRs. For sending one mic or line source to two destinations at short range.
Strong match
Who this is for
- Feeding one signal to a console and a recorder simultaneously
- Tight patch bays where a long splitter cable would coil up
- Short runs between rack gear inputs at the same position
Consider the trade-offs
When to look elsewhere
- Combining two mics into one input — that loads sources against each other
- Anyone needing reach; one foot goes almost nowhere
- Splits needing isolation, where a transformer splitter belongs instead
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Female XLR to two male XLR
The female end takes the mic or source cable; the two male ends go into two inputs.
Detail 03
Passive Y split
No transformer or buffer, so both destinations share the source. Level can drop on some sources.
Detail 04
Black jacket
Disappears in a dark rack or on a stage floor. Label the ends if you need to trace it.
Final check
Know before you order
- 01No transformer isolation — ground loops between the two destinations can still hum
- 02Phantom power fed to both male ends reaches the source together, not separately
- 03You still need standard XLR cables to reach the mic and the inputs
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I use this to plug two microphones into one input?
Not recommended. It is built to split one source to two destinations. Running two mics into it makes them load each other and degrades both signals.
02Will phantom power pass through it?
It passes through the connection, but with both male ends tied together the source sees whatever the destinations supply. Use one phantom source, not two.
03Does splitting cut my signal level?
It can. A passive split divides the source across two inputs, so you may see a drop depending on the source and the input impedances.
04Is one foot really long enough?
Only for gear sitting side by side or in the same rack. Plan on regular XLR cables to cover any actual distance.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black
