Detail 01
36 ohm impedance, 107dB sensitivity
Loud off almost anything — phone, laptop, mixer cue out. No headphone amp needed.

Independent shopping perspective
Closed-back DJ headphones with 50mm drivers and a coiled cord. For booth monitoring where isolation and volume matter more than a flat mix.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01
Loud off almost anything — phone, laptop, mixer cue out. No headphone amp needed.
Detail 02
Takes hard cue-level output from a club mixer without the driver giving up.
Detail 03
Big diaphragm moves more air, so kick and low bass stay readable next to a loud system.
Detail 04
Slack when you step back from the deck, recoil so it stays off the floor.
Detail 05
Middleweight. Noticeable on a long set, but not the heaviest thing in a booth.
Detail 06
Range extends past hearing at both ends; the audible effect is mostly extension at the bottom.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Yes. At 36 ohms and 107dB sensitivity they reach full volume from a phone or laptop jack without an amp.
They're built for cueing in loud rooms. For mix decisions you want something tuned flatter; use these for monitoring and checking.
1.2m coiled at rest, stretching to about 3m. Enough to move around a booth and pull back.
No. Wired only, with the cord entering one side.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.