Detail 01
Pedal stabilizer board
Both pedal halves bolt to one plate, so the slave stays at the distance you set relative to the primary.

Independent shopping perspective
A stabilizer board that locks a double pedal's two halves together so they stop drifting apart mid-song.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Both pedal halves bolt to one plate, so the slave stays at the distance you set relative to the primary.
Detail 02
Solves the specific problem of the slave pedal walking away from the hi-hat side during a set.
Detail 03
Ties the pedal assembly to the drum, so the whole unit moves together instead of the drum creeping forward.
Detail 04
Designed around Pearl pedal footprints. Other brands may bolt up, but hole spacing is worth verifying.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It's built around Pearl pedals. Other pedals may mount if the baseplate holes line up, so measure before buying.
Yes. This stops the two pedals from shifting relative to each other; a rug is what stops the whole rig sliding on the floor.
It's made for double-pedal setups. A single pedal has no second half to align, so there's little reason to add one.
Yes. Once the spacing is set, both pedals go down as one piece instead of being re-measured each time.