Detail 01
Revolving design
The mount rotates, so you can set angle without moving the clamp along the tube.
Product detailSKU #1274034489037
PearlAx-25 Adapter 2 Hole Revolving
Independent shopping perspective
The Korena take
A two-hole revolving adapter for repositioning drum hardware mounts. Useful when a stand or rack puts an accessory at the wrong angle.
Strong match
Who this is for
- Angling a tom or accessory holder away from its stock position
- Adding a second mount point to one clamp
- Fixing reach problems in a crowded kit layout
Consider the trade-offs
When to look elsewhere
- Anyone who does not already have a clamp to attach it to
- Players whose current mounts already sit where they want
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Two holes
Takes two rods or arms from one attachment point, which frees up rack space.
Detail 03
Adapter, not a stand
It extends existing hardware. You need a clamp or stand already in place.
Detail 04
Around $71
A single hardware part. Building a full mount means adding a clamp and arm on top.
Final check
Know before you order
- 01Check the rod diameter your holders use before ordering
- 02No clamp, arm or holder included
- 03Revolving joints work loose over time — retighten between gigs
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What does this actually do?
It gives you two rotating mount holes off one point, so you can angle and position accessories that a fixed clamp puts in an awkward spot.
02Do I need anything else to use it?
Yes. It attaches to an existing clamp or stand, and you supply the arm or holder that goes into it.
03Will it hold a rack tom?
It accepts hardware rods and revolves to set angle. Heavier loads mean more leverage, so tighten firmly and check it after playing.
04Does it fit non-Pearl hardware?
Depends on rod diameter. Measure the rods on your holders and compare rather than assuming brand compatibility.
