Detail 01
5/8 inch-27 threading
The US standard mic thread. Clips and shockmounts sold in the US screw straight on; 3/8 inch hardware needs an adapter.
Product detailSKU #1313854567146
On-StageTM01 Mic Table/Stand Clamp
Independent shopping perspective
The Korena take
A clamp that mounts a mic to a desk edge or a stand tube. For desk recording or adding a mic where a floor stand won't fit.
Strong match
Who this is for
- Podcast and streaming desks with no floor space
- Adding a second mic to an existing stand tube
- Drum or amp mic placement where a base won't fit
Consider the trade-offs
When to look elsewhere
- Desks thicker than 1.625 inches at the clamp point
- Players who need the mic reaching out over the desk
- Mic clips with 3/8 inch European threading
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Clamp range .625 inch–1.625 inch
Covers most desktops and tabletops, and also fits around round stand tubing in that diameter range.
Detail 03
Mounts to desktop or stand
One clamp does both jobs, so it moves from a home desk to a stage stand without extra parts.
Detail 04
Black and chrome finish
Low visual profile on camera for the black body, with chrome on the threaded hardware where wear shows most.
Final check
Know before you order
- 01Measure your desk at the exact edge you'll clamp — many taper thinner than the top
- 02Check your mic clip's thread: 5/8 inch-27 here, 3/8 inch needs an adapter
- 03A clamped desk transmits typing and knocks straight into the mic
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will it clamp to my desk?
If the desk edge measures between .625 and 1.625 inches thick, yes. Measure the actual clamping spot — desktops often thin out toward the edge.
02Does it fit a standard mic clip?
It uses 5/8 inch-27 threading, the US standard for mic clips and shockmounts. A 3/8 inch clip requires a thread adapter.
03Can I mount it on a mic stand instead of a desk?
Yes. It clamps round stand tubing as well as flat surfaces, within the same .625 to 1.625 inch range.
04How is this different from a desk boom arm?
This is a clamp mount only — it holds the mic at the desk edge rather than swinging it out over the desk. Less reach, far less to go slack or sag.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Black and chrome
4 detailsOther
- Product Type
- Mic clips/mounts
- Application
- Mount for desktop or stand
- Threading
- 5/8 inch-27
- Clamp
- .625 inch–1.625 inch
