Detail 01
152 lb capacity
Handles heavy tube combos and 2x12s, not just small practice amps. Capacity is not the limiting factor here.
Product detailSKU #1274115029533
On-StageRS7000 Tiltback Amp Stand
1/5
Independent shopping perspective
The Korena take
Steel tiltback stand that lifts a combo amp off the floor and angles it toward your ears. For gigging players who can't hear their amp on stage.
Strong match
Who this is for
- Small combos buried behind drums at a floor-level gig
- Studio monitor placement where you need a fixed tilt angle
- Anyone losing high end because the amp fires at their knees
Consider the trade-offs
When to look elsewhere
- Full or half stacks — this is a combo and monitor stand
- Players wanting bass coupling from the floor for low end
- Rigs needing lift past 24 inches
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
17 to 24 inch height range
Aims sound at your ears when standing, instead of your calves. That's the whole point of the stand.
Detail 03
All-steel construction
Won't flex under a heavy amp or creep out of position mid-set. Adds weight to your load-in.
Detail 04
15-1/2 inch base spread
Compact footprint on a crowded stage, but check stability with tall narrow cabs.
Detail 05
12 inch upper and lower arms
Cradles standard combo depths. Very deep or very shallow cabinets may sit past the arm ends.
Detail 06
12 inch width
The frame is narrower than most combos, so the cab overhangs the sides. Normal for this design.
Final check
Know before you order
- 01Measure your amp's depth and bottom width against the 12 inch arms
- 02Tilting an open-back amp changes how it couples with the room
- 03Steel adds weight — factor it into what you carry to gigs
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will it hold a 2x12 combo?
Weight is not an issue at 152 lbs. The question is footprint — check that your cabinet's depth works with the 12 inch arms and that it sits stable at your chosen tilt.
02How high does it actually lift the amp?
The stand adjusts from 17 to 24 inches. Your amp sits on top of that, so the speaker ends up substantially higher than floor level.
03Can I use this for a PA monitor?
Yes. It's built for stage and studio amplifiers and monitors, and the tilt is useful for aiming a wedge.
04Is it adjustable for tilt angle?
It's a tiltback design with 17 to 24 inch height adjustment. Height adjustment is what sets the angle the cabinet ends up at.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
2 detailsBody & build
- Color
- black powder coat finish
- Construction
- all-steel
4 detailsSize & weight
- Weight Capacity
- 152 lbs.
- Upper and Lower Arm Length
- 12 inch
- Height Adj
- 17 inch to 24 inch
- Width
- 12 inch
2 detailsOther
- Base Spread
- 15-1/2 inch
- Applications
- stage/studio amplifiers and monitors
