Detail 01
Crank mechanism
You load the fixtures low and wind them up. One person can raise weight that would need two on a manual stand.
Product detailSKU #1274115053683
OdysseyLTP8-PRO Crank Truss Stand
Independent shopping perspective
The Korena take
A crank-up truss stand for lifting lighting or speakers overhead. For mobile DJs and small production crews working alone.
Strong match
Who this is for
- Mobile DJ raising a lighting bar solo
- Small venue installs needing repeatable height
- Loading fixtures at waist height, then cranking up
Consider the trade-offs
When to look elsewhere
- Anyone needing a single cheap tripod for one light
- Heavy line array or large moving-head loads
- Setups with no vehicle space for a stand this size
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Truss column
A trussed section resists twist and flex better than a plain tube, so a loaded top stays steadier.
Detail 03
Stand, not a fixture
Rated by load and height. Check both against the total weight of everything you plan to hang.
Detail 04
Price above basic tripods
You are paying for the crank and the truss section. Simple T-bar tripods cost a fraction and lift far less.
Final check
Know before you order
- 01Confirm the load rating covers your fixtures, clamps and cabling together
- 02A T-bar or crossbar for mounting may be a separate purchase
- 03Measure your trunk — crank stands are long and heavy folded
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can one person set this up?
That is the point of the crank. Load the bar at low height, then wind up. Moving the stand between gigs is still awkward alone.
02Will it hold a speaker?
Crank stands are used for both lighting and speakers, but only within the rated load. Verify the rating before hanging a cabinet on it.
03Do I need two?
Two if you are spanning a crossbar or truss between them. One is fine for a single bar of lights on one side of a stage.
04How do I keep it from tipping?
Spread the legs fully, keep the load centered, and sandbag the base. Outdoor use with any wind needs weight and ideally guy lines.
