Detail 01
6 rack spaces
10.5 inches of vertical rail. Add up your gear's rack units first; a power conditioner alone eats one.

Independent shopping perspective
A carpeted combo case holding a mixer up top over six rack spaces. For mobile DJs and small PA rigs that set up and tear down often.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
10.5 inches of vertical rail. Add up your gear's rack units first; a power conditioner alone eats one.
Detail 02
The mixer sits accessible up top while processors and amps live below. One case instead of two to load.
Detail 03
Absorbs scuffs and hides wear better than molded plastic, but it holds dust and takes longer to dry if it gets wet.
Detail 04
Loaded with an amp and receivers this gets heavy fast. Plan on a hand truck or a second person.
Detail 05
Usable rack depth is less than that once you account for rails and lid. Deep power amps may not clear.
Detail 06
Compact enough to sit on a table or under a DJ booth, and it stacks reasonably in a car trunk.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Six standard 1U units, or fewer if you have 2U amps. A typical mobile rig runs a power conditioner, an amp and a wireless receiver or two.
No. A carpeted case is built for van and trunk transport, not airline baggage handling. Use a molded flight case for air travel.
Check your mixer's width and depth against the case's top section. Larger club and live consoles will overhang the opening.
No. Buy rack screws and washers separately, and use washers so you do not chew up the rails or your gear's faceplates.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.