Detail 01
2 x 50W RMS into two internal 5-inch drivers
Enough for personal stage level in a small room. It is a near-field monitor, not front-of-house coverage.
Product detailSKU #1274034485898
NadyPM-200A Powered Personal Stage Monitor
Sale
1/5
Independent shopping perspective
The Korena take
A self-powered 5-inch personal monitor with mic and line inputs, three-band EQ and 100W total. For hearing yourself on a small stage.
Strong match
Who this is for
- Vocalists needing a dedicated wedge at their own volume
- Keyboard or guitar players on a crowded small stage
- Rehearsal rooms where one player needs a separate mix
Consider the trade-offs
When to look elsewhere
- Drummers or bassists who need low end you can feel
- Loud full-band stages where 5-inch drivers get buried
- Anyone wanting in-ear monitoring instead of a wedge
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
5-inch full-range speakers
Clear on vocals and midrange. Kick drum and bass guitar will not come through with any weight.
Detail 03
XLR mic input plus balanced/unbalanced TRS line input
Take a mic straight in, or a line feed from a mixer, without an extra preamp or DI box.
Detail 04
Three-band EQ, ±12dB at 120Hz / 2.5kHz / 10kHz
Wide 12dB range at each band. The 2.5kHz control is where you cut to kill stage feedback.
Detail 05
Balanced XLR line output
Pass the same signal on to another monitor or back to the board without splitting the source.
Detail 06
Two external 1/4-inch speaker outputs
Drive extra 8-ohm cabinets from the built-in amps to cover a second position on stage.
Detail 07
20Hz–50kHz frequency response
That is the electronics' range, not the drivers'. The 5-inch speakers set the real low-end limit.
Detail 08
Selectable 115V/230V power
A switch, not automatic. Set it to your local voltage before plugging in the first time.
Final check
Know before you order
- 01Check the voltage selector matches your outlet before first power-up
- 02Mic, cables and stand or mount are not included
- 039.6 lb and 11 x 7 x 6 inches — sits on a stand or table
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can I plug a microphone straight into it?
Yes. It has a balanced XLR mic input, so a dynamic mic goes directly in with no outboard preamp needed.
02Will it work as a drum monitor?
Not well. Two 5-inch drivers will reproduce the snare and cymbals but not the kick weight drummers listen for.
03Can I run a second speaker off it?
Yes. Two 1/4-inch outputs feed external 8-ohm cabinets from the internal 100W of amplification.
04How do I stop it from feeding back?
Pull the 2.5kHz mid control down and keep the monitor behind or beside the mic, off its pickup axis.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
4 detailsSound
- Impedance
- 8 ohms
- Internal Speakers
- 5 inch full-range
- Frequency Response
- 20Hz ” 50KHz
- Power
- 2 x 50W RMS @ 8 ohms (Total 100W RMS)
1 detailsBody & build
- Color
- Red
11 detailsConnections & power
- Line Input
- balanced/unbalanced TRS 1/4 inch
- Mic Input
- balanced XLR
- Headphone Output
- 1/4 inch TRS Stereo
- Maximum Output W 10k Load
- 15.5dBm (4.3V)
- Input Impedance
- 20K ohms (10K ohms unbalanced)
- Power Amp Output
- 2 internal speakers, 2 external 1/4 inch outputs
- Output Impedance
- 1.4kOhm
- Power Requirements
- Selectable, 115VAC/60Hz or 230VAC/50Hz
- Maximum Input
- +22dBm (10V)
- Line Output
- balanced XLR
- Sensitivity For Max Output W Volume Max
- -10dBm (230mV)
3 detailsSize & weight
- Voice Coil Diameter
- 1 inch
- Weight
- 9.6
- Dimensions Hwd
- 11.1 inch x 7 inch x 6.1 inch (28 x 18 x 15.5 cm)
9 detailsOther
- Mid
- +/-12dB @ 2.5K Hz
- High
- +/-12dB @ 10K Hz
- Fuse Requirements
- 5x20mm glass tube F.B. 6A 250V @ 115VAC
- S N
- -81dB
- EQ and Volume
- rotary knobs
- Noise Floor
- 200uV
- Bass
- +/-12dB @ 120 Hz
- Thd
- 0.055%
- Amplifier Protection
- clipping LED's, thermal runaway, short circuit, anti-thump on/off protection
