Detail 01
13 inches of reach
Enough to clear a drum rim or cross over a desk edge, short enough to stay stable with a light mic.
Product detailSKU #1290447863888
Musician's GearGoose Neck Chrome 13 in.
1/2
Independent shopping perspective
The Korena take
A 13-inch chrome gooseneck for mounting a microphone at an angle off a stand. For anyone who needs the mic where the stand will not reach.
Strong match
Who this is for
- Aiming a mic into a kick drum port or under a snare
- Podcast or desk setups where the boom sits below mouth level
- Amp cab miking where a straight stand fouls the grille
Consider the trade-offs
When to look elsewhere
- Heavy large-diaphragm condensers — the neck will sag
- Anyone needing a full stand; this attaches to one
- Setups where the mic gets bumped often and must hold position
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Gooseneck, not a rigid arm
Bends and holds anywhere along its length. You aim by hand rather than adjusting joints.
Detail 03
Chrome finish
Resists corrosion from sweat and humidity better than bare steel. Also reflects stage light, which matters on camera.
Detail 04
Under $15
Entry-tier build. Fine for light mics; a heavy mic on a long bend will droop over a set.
Final check
Know before you order
- 01Confirm your stand and mic clip use standard 5/8-inch threads
- 02No mic or clip included — this is the neck only
- 03Lighter mics hold position far better; weight is the failure point
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What thread size is it?
Goosenecks in this class use the standard 5/8-inch 27 thread common on mic stands, usually with an adapter for 3/8-inch. Verify against your stand and clip before ordering.
02Will it hold a heavy condenser?
Not well. A 13-inch gooseneck holds position with a light dynamic mic. A heavy large-diaphragm condenser at full extension will slowly droop.
03Does it come with a microphone clip?
No. This is the gooseneck alone. You attach your own clip on one end and thread the other onto a stand.
04Can I use it on a desk stand?
Yes, as long as the threads match. It is a common way to get a mic up to mouth height on a low desk stand without buying a boom arm.
