Detail 01
Steel construction
Bright, hard attack with long ring. Louder and more piercing than brass or bronze bells at the same size.
Product detailSKU #1274115063405
MEINLMEINL STBAB2 STEEL A GO GO BELL LARGE Large
1/6
Independent shopping perspective
The Korena take
Large steel a-go-go bell for percussion setups. For players who need a single loud, cutting bell voice.
Strong match
Who this is for
- Latin and Afro-Cuban percussion patterns needing a low bell
- Drummers mounting a bell voice on a kit or rack
- Loud stages where a bell has to cut through
Consider the trade-offs
When to look elsewhere
- Players wanting a paired high-low a-go-go set
- Quiet acoustic settings — steel bells are unforgiving
- Anyone after a warm, mellow bell tone
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Large size
Lower pitch and more sustain than a small bell. Better as a foundation voice than a fast, chattering accent.
Detail 03
Single bell
One pitch, not a two-bell a-go-go pair. Pitch variation comes from where and how hard you strike it.
Detail 04
Price around $60
Sits at the accessory end of a percussion rig. Cheap enough to add a bell voice without rebuilding a setup.
Final check
Know before you order
- 01Plan a clamp or mount — this needs somewhere to hang on your rig
- 02Steel rings long; a strip of tape damps it if needed
- 03A wood stick or bell beater controls tone better than a drumstick tip
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does this come with a mount or clamp?
Budget for a clamp or holder. A go go bell is normally clamped to a rack, cymbal stand or percussion table rather than held by hand on a gig.
02Can I mount it on a drum kit?
Yes. A standard percussion clamp on a cymbal stand or rack tube is the usual approach, positioned within easy reach of one hand.
03What should I hit it with?
A wood stick or dedicated bell beater. Striking near the open mouth gives an open ring; striking the shoulder gives a tighter, drier note.
04How does steel compare to a brass bell?
Steel is brighter and harder-edged, with more cut and longer ring. Brass reads warmer and rounder. Choose steel when volume is the priority.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- Gray
