Detail 01
Snare butt, not a strainer
This is the fixed end that clamps the wires. Tension and on/off still happen at the throw-off side.
Product detailSKU #1274115057928
LudwigP-32 Snare Butt
Independent shopping perspective
The Korena take
A replacement snare butt plate — the anchor end that holds the snare wires opposite the strainer. A repair part for Ludwig snare drums.
Strong match
Who this is for
- Fixing a snare where the butt end is stripped, bent, or missing
- Drum techs keeping common Ludwig repair parts on the shelf
- Restoring an older Ludwig snare back to working order
Consider the trade-offs
When to look elsewhere
- Anyone needing the throw-off; that's the other side of the drum
- Players expecting a tone upgrade — this is hardware, not sound
- Non-Ludwig drums without checking the mounting hole pattern first
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Ludwig P-32
A stock Ludwig part number, so it lines up with Ludwig's existing shell drilling on the drums it was made for.
Detail 03
Under $10
Cheap enough to keep a spare. Butt plates get stripped by overtightening far more often than they break.
Detail 04
Bolt-on shell hardware
Swapping it means pulling the bottom head and wires, so budget a few minutes of downtime, not a quick fix mid-gig.
Final check
Know before you order
- 01No snare wires, cord, straps, or mounting screws assumed — check what you're missing
- 02Match the hole spacing to your existing shell drilling before drilling anything new
- 03Note whether your wires use cord or plastic straps; the attachment differs
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What does a snare butt actually do?
It's the fixed anchor holding one end of the snare wires against the bottom head. The throw-off on the opposite side handles tension and engagement.
02Will this fit a non-Ludwig snare?
Sometimes. It depends on hole spacing and shell drilling. Measure your existing plate's mounting holes against it before committing.
03Does it include snare wires?
No. This is the butt plate. Wires and the cord or straps that attach them are separate.
04Do I need to remove the bottom head to install it?
Yes. You'll pull the resonant head and detach the wires to get at the mounting screws, then retune the head afterward.
