Detail 01
Bell-section support
The horn rests on its bell, so weight sits low and the slide points up out of harm's way.
Product detailSKU #1274115058505
K&MPrecision Trombone Stand
1/6
Independent shopping perspective
The Korena take
A folding stand that holds a trombone upright by its bell section. For players who need somewhere safe to set the horn down between sets.
Strong match
Who this is for
- Rehearsal and pit work where the horn goes down often
- Doubling players switching between instruments mid-set
- Keeping a horn off a chair or the floor
Consider the trade-offs
When to look elsewhere
- Players wanting a stand that stays attached while playing
- Anyone needing one stand for horn and mutes together
- Marching use, where a stand is dead weight
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Folding legs
Collapses to fit alongside the horn in a gig bag pocket or case compartment.
Detail 03
Trombone-specific design
Sized for a trombone bell throat, not a general-purpose stand you shim to fit.
Detail 04
K&M build
German-made stands in this line are built to be stepped on and keep working; the price reflects that.
Detail 05
$89.99
Above the cost of a generic folding stand, which buys stability and a longer service life.
Final check
Know before you order
- 01Confirm your bell diameter sits in the stand's range before ordering
- 02Nothing else is included — no mute holder, no bag
- 03Needs a flat floor; risers and cable runs make any bell stand tippy
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does it hold a bass trombone?
Bass trombones have larger bells and heavier slides. Check the bell diameter the stand accepts against your horn before buying.
02Can I leave the slide on the horn while it's on the stand?
Yes. The horn stands assembled, bell down and slide up, which is the point of the design.
03Does it fold small enough to travel?
The legs fold in for transport. It goes in a case pocket or bag rather than needing separate carriage.
04Will it scratch the lacquer?
Contact points on K&M stands are padded to protect finish. Keep the pads clean, since grit trapped underneath is what causes marks.
