Detail 01
3.5mm stereo male end
Fits a headphone or line output jack. Tip and ring carry left and right, split out to the two RCA plugs.

Independent shopping perspective
Three-foot Y-cable splitting a 3.5mm stereo plug into left and right RCA plugs. For sending a phone, laptop, or player into RCA inputs.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Fits a headphone or line output jack. Tip and ring carry left and right, split out to the two RCA plugs.
Detail 02
Goes into RCA input jacks. It cannot connect to gear that has RCA plugs sticking out.
Detail 03
Enough to reach a mixer sitting beside you. Not enough to reach across a stage or room.
Detail 04
Susceptible to hum over distance or near power cables. Keep the run short and away from AC lines.
Detail 05
It separates one stereo signal into two mono channels. It does not duplicate one source to two destinations.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Only if the mixer input is 3.5mm and the turntable has RCA outputs, and this cable's RCA ends are male, so they will not mate with a turntable's male RCA plugs.
Electrically yes, if the RCA ends go into output jacks and the 3.5mm end into an input. Both ends are male, so the jack genders have to line up.
Yes. The tip and ring of the 3.5mm plug feed the two RCA plugs separately, so left and right stay independent.
Only if the phone sits right at the mixer. For anything farther you would need a longer cable or an extension.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.