Detail 01
Bridge spacing
Bridge humbuckers often use wider pole spacing than neck ones. A neck-spaced cover will not line up with the strings.
Product detailSKU #1273888006538
GibsonBridge Humbucker Cover Nickel
Independent shopping perspective
The Korena take
Nickel humbucker cover for a bridge-position pickup. For covering an exposed pickup or replacing one that is scratched or mismatched.
Strong match
Who this is for
- Converting an open-coil bridge pickup to a covered look
- Matching hardware after a nickel-to-chrome mismatch
- Replacing a dented or corroded cover on an older guitar
Consider the trade-offs
When to look elsewhere
- Single-coil or P-90 pickups — wrong footprint entirely
- Players chasing brighter, more aggressive top end from open coils
- Anyone unwilling to solder, since the cover has to be attached
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Nickel silver cover
Metal covers roll off a little top end and tame some highs. The change is small but audible on a bright bridge pickup.
Detail 03
Nickel finish
Matches nickel bridges and tuners. Against chrome parts the warmer, less mirror-like tone of the metal shows.
Detail 04
Cover only
No pickup, no mounting ring, no wire. This slips over a pickup you already own.
Final check
Know before you order
- 01Check your pickup's pole spacing before ordering — neck and bridge units differ
- 02Attaching a cover normally means soldering it to the baseplate to stop microphonic squeal
- 03Some pickups sit too tall in their bobbins to accept a cover without adjustment
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this fit any humbucker?
It fits standard bridge-spaced humbuckers. Narrower neck-position pickups and non-standard sizes will not line up under the strings.
02Does covering a pickup change the sound?
Slightly. A metal cover shaves a bit off the highest frequencies, so the pickup sounds a touch smoother. Most players find it subtle.
03Do I have to solder it on?
Practically, yes. An unsoldered cover can vibrate and squeal at high gain. Soldering it to the baseplate stops that.
04Can I use this on a neck pickup?
Only if your neck pickup uses bridge pole spacing, which is uncommon. Check the pole positions against your strings first.
