Detail 01
30 in. length
A short run. Fits side extensions and single-tom sections, not a full front bar across the kit.

Independent shopping perspective
A 30-inch straight chrome tube for Gibraltar rack systems. Buy it to extend or repair an existing rack, not as a standalone stand.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
A short run. Fits side extensions and single-tom sections, not a full front bar across the kit.
Detail 02
No bends, so it clamps anywhere along its length and cuts square into any rack section.
Detail 03
Sized to Gibraltar's own clamps. Verify diameter before pairing with another brand's hardware.
Detail 04
It is the pipe only. Every mounting point needs its own clamp purchased separately.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. This is the tube alone. Multi-clamps, right-angle clamps and leg assemblies are sold separately and are what actually hold cymbals, toms and modules to the tube.
Only if the tube diameters match. Check your existing tube against Gibraltar's spec before ordering, since clamps are cut for a specific diameter and will slip or fail to close otherwise.
Usually not. Thirty inches suits a side extension or a short single-tom section. A full front bar spanning a kit typically needs a considerably longer tube.
Yes, chrome tube can be cut to length with a pipe cutter. Deburr the cut end so clamps seat flat and slide on without scoring.