Detail 01
2-hole design
Two mounting points on one clamp, so one grab on the rack supports two pieces of hardware.
Product detailSKU #1273887992747
GibraltarSC-SUGC 2-Hole Super Universal Grabber Clamp
1/2
Independent shopping perspective
The Korena take
A two-hole rack clamp for mounting hardware onto drum rack tubing. For drummers adding cymbal arms, toms or accessories to a rack.
Strong match
Who this is for
- Hanging a cymbal arm and a tom holder from one point on a rack
- Joining a rack extension tube to an existing rack bar
- Repositioning existing mounts without rebuilding the rack
Consider the trade-offs
When to look elsewhere
- Drummers who need only a single accessory mounted
- Anyone without an existing rack or tube to clamp onto
- Players wanting a clamp that attaches to a cymbal stand leg
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Grabber clamp
Opens around the tube rather than requiring the tube end, so you can add it mid-span without disassembling the rack.
Detail 03
Super Universal
Sized to accept common hardware shaft diameters, not just one accessory type.
Detail 04
$54.99
Priced above single-hole clamps, but doing the job of two of them and taking up one spot on the bar.
Final check
Know before you order
- 01Clamp only; no cymbal arm, tom holder or tube included
- 02Verify your rack tube diameter and your accessory shaft diameter both fit
- 03Two loaded arms on one clamp puts real leverage on that spot; tighten fully and check after playing
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What diameter tube does it fit?
It is built for standard drum rack tubing. Measure your rack tube before ordering, since clamp jaws are sized to a diameter range rather than fitting anything.
02Can I mount two cymbal arms on it?
Yes, that is the point of the two holes. Balance the load across both sides so the clamp is not pulled hard in one direction.
03Does it work on cymbal stand tubing?
Only if that tubing falls in the same diameter range as rack tube. Stand tubes are often tapered, which does not clamp reliably.
04Do I still need memory locks?
Helpful but not required. The clamp holds position once tightened; memory locks just let you return to the same height after teardown.
