Detail 01
Pipe cutter, not a saw
It scores and rolls through the tube instead of tearing it, so the cut edge stays round and square.
Product detailSKU #1273887992802
GibraltarPipe Cutter
Independent shopping perspective
The Korena take
A hand tool for cutting drum rack tubing to length. For anyone building or resizing a Gibraltar-style rack setup.
Strong match
Who this is for
- Trimming rack bars to fit a tight kit footprint
- Building a custom rack layout from full-length pipe
- Drum techs who reconfigure setups between rooms
Consider the trade-offs
When to look elsewhere
- Players with a fixed factory rack that already fits
- Anyone who only needs one cut — a shop can do it
- Cutting anything other than round tubing
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Hand-operated
No power needed. Slower than a chop saw but far more controllable, and it will not walk off the mark.
Detail 03
Sized for drum rack tubing
Built around the diameter range of rack bars, not household plumbing runs.
Detail 04
Under $50
Cheaper than paying a shop for a couple of custom cuts, so it pays back on the second rack change.
Final check
Know before you order
- 01Measure twice — a cut bar cannot be lengthened again
- 02Deburr and smooth the cut end before sliding on clamps
- 03No rack tubing or clamps come with the cutter
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this cut my drum rack bars?
Yes — that is what it is for. Check your tube diameter falls inside the cutter's jaw range before ordering.
02Do I need power tools too?
No. It works entirely by hand: tighten the wheel, rotate around the tube, tighten again, repeat until it parts.
03Will the cut end still take a clamp?
Yes, provided you clean up the inner burr. A rolled cut leaves the tube round, which is what clamps need.
04Can I cut chrome tubing without wrecking the finish?
Yes. Keep the cutter square and advance the wheel in small turns — forcing it is what marks and deforms the tube.
