Korena
Product detailSKU #1273887993127

GibraltarMicrophone Gooseneck 6 in.

Gibraltar
Gibraltar Microphone Gooseneck 6 in.
1/4

Independent shopping perspective

The Korena take

Six-inch flexible gooseneck extension for a microphone mount. Buy it when a mic clip needs a few inches of reach and fine angle control.

Gibraltar Microphone Gooseneck 6 in. product detail
Product studyGibraltar Microphone Gooseneck 6 in.
Gibraltar Microphone Gooseneck 6 in. alternate view
Alternate view

Strong match

Who this is for

  • Getting a mic inside a kick drum port or under a snare
  • Fine-tuning mic angle without moving the whole stand
  • Tight stages where the stand cannot get closer

Consider the trade-offs

When to look elsewhere

  • Heavy large-diaphragm mics that will droop on a short neck
  • Anyone needing more than six inches of extra reach
  • Players wanting a full stand — this is an add-on only

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Gibraltar Microphone Gooseneck 6 in. construction detail

Detail 01

6 in. length

Short reach. Enough to clear a rim or reposition an angle, not enough to bridge across a drum kit.

Detail 02

Gooseneck construction

Bends and holds position, so you can aim the mic by hand instead of loosening and retightening a joint.

Detail 03

Threaded on both ends

Sits between the stand and the mic clip, using standard mic thread so it drops into existing hardware.

Detail 04

Steel core flexibility

Holds a bend under a light mic. Heavier mics can slowly sag as the neck settles.

Final check

Know before you order

  1. 01Microphone, clip, and stand are not included
  2. 02Check whether your stand and clip use matching thread sizes; an adapter may be needed
  3. 03Short goosenecks hold light mics best — a heavy mic will sag

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01What thread size does it use?

It uses standard microphone stand thread and sits between the stand and the clip. If your clip and stand differ, a thread adapter handles it.

02Will it hold a heavy condenser?

A six-inch neck holds light dynamic mics well. Heavy large-diaphragm condensers can droop over the course of a set.

03Can I use this inside a kick drum?

Yes. Six inches is enough to reach through a port and aim the mic at the beater or shell without dragging the stand closer.

04Do I need a mic clip too?

Yes. This is the gooseneck only. You supply the stand, the clip, and the microphone.