Detail 01
Metric thread
Metric and imperial rods look nearly identical but will not accept each other's clutches. The thread pitch decides fit, not the diameter.
Product detailSKU #1273887992709
GibraltarMetric Hi-Hat Stand Upper Rod
Independent shopping perspective
The Korena take
A replacement upper pull rod for metric-threaded Gibraltar hi-hat stands. For repairing a stand with a bent, stripped or missing rod.
Strong match
Who this is for
- Fixing a hi-hat stand after the rod bends from a hard case
- Replacing a rod with stripped threads at the clutch end
- Keeping a spare in the hardware bag for gig-night failures
Consider the trade-offs
When to look elsewhere
- Stands with US/imperial threading — the clutch will not seat
- Anyone needing the lower rod or the full pull-rod assembly
- Drummers with a non-Gibraltar stand of unknown thread pitch
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Upper rod only
This is the section the clutch threads onto. The lower rod and the footboard linkage are separate parts.
Detail 03
Hi-hat pull rod
Carries the full pedal stroke to the top cymbal. A bent one drags in the tube and slows the chick response.
Final check
Know before you order
- 01Confirm your stand is metric — thread your existing clutch onto the old rod to compare
- 02The clutch, top cymbal felt and wing nut are not included
- 03A bent rod often means a worn nylon bushing in the upper tube; check that too while it is apart
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How do I know if my stand is metric or US thread?
Test-fit your hi-hat clutch. If it spins on smoothly and grips, the thread matches. If it binds after a turn or two, the pitch is different.
02Does this include the clutch?
No. This is the rod only. Reuse your existing clutch or buy one separately.
03Will this fit a two-piece pull rod stand?
It replaces the upper section. If your stand uses a single one-piece rod, this will not couple to anything.
04Why did my old rod bend?
Usually transport — the stand packed in a case with the rod extended. Collapse the upper tube fully before it goes in the bag.
