Detail 01
10.5mm diameter
The critical number. Your clamp or bracket must accept 10.5mm or the rod will slip or not enter.
Product detailSKU #1273887992918
GibraltarL-Arm 10.5mm
Independent shopping perspective
The Korena take
A 10.5mm L-shaped mounting rod for drum hardware. Goes between a mount and a tom, cymbal arm, or accessory to set position.
Strong match
Who this is for
- Repositioning a tom that will not reach where you want it
- Replacing a bent or seized arm on existing hardware
- Adding an accessory mount to a rack or stand
Consider the trade-offs
When to look elsewhere
- Hardware built around 12.7mm or 9.5mm rods — diameter must match
- Anyone needing the clamp too; this is the arm alone
- Heavy floor toms hung far off a single point
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
L-arm shape
The right angle lets you gain height on one leg and reach on the other, so you can clear other drums.
Detail 03
Gibraltar hardware
Gibraltar sizing is common across aftermarket drum hardware, so it often mates with other brands using the same diameter.
Detail 04
Single arm, sold alone
You supply the clamp, memory lock, and mount. This is one piece of a larger assembly.
Final check
Know before you order
- 01Measure your existing rod with calipers — 10.5mm and 12.7mm look similar
- 02No clamp, memory lock, or tom bracket included
- 03Check arm length against the reach you actually need before ordering
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01How do I know if my drum uses 10.5mm?
Measure the existing rod with calipers or a ruler. Many entry and mid-level kits use 10.5mm; heavier pro hardware often runs 12.7mm.
02Can I mount a cymbal on this?
It can carry a light cymbal arm or accessory, but a 10.5mm rod is thinner than a dedicated cymbal boom. Keep loads modest and close in.
03Does it include a clamp?
No. This is the L-arm only. You need a compatible clamp or bracket sized for 10.5mm to attach it.
04Will it fit non-Gibraltar hardware?
Often yes, if that hardware takes 10.5mm rods. Diameter matters more than brand, but check any brand-specific bracket shapes.
