Korena
Product detailSKU #1273887993119

GibraltarChrome Tom Drum Hoop 10 in. 6-Lug

Gibraltar
Gibraltar Chrome Tom Drum Hoop 10 in. 6-Lug
1/2

Independent shopping perspective

The Korena take

A replacement 10-inch chrome tom hoop with 6 lug holes. For repairing a bent or corroded hoop, or matching hardware across a kit.

Gibraltar Chrome Tom Drum Hoop 10 in. 6-Lug product detail
Product studyGibraltar Chrome Tom Drum Hoop 10 in. 6-Lug

Strong match

Who this is for

  • Replacing a hoop bent by a hard rim shot
  • Restoring an older kit with pitted or rusted hardware
  • Matching chrome finish across mismatched drums

Consider the trade-offs

When to look elsewhere

  • Toms with 8 lugs — the hole spacing will not line up
  • Anyone wanting die-cast tone; this is a triple-flange type part
  • Sizes other than 10 inch

What matters in use

The specifications, translated

Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.

Detail 01

10 in.

Matches the drum's shell diameter, not its depth. Measure the shell across, not the head packaging.

Detail 02

6-lug

Hole count must match your drum's lug count exactly. A 6-lug hoop will not fit an 8-lug tom.

Detail 03

Chrome

Plated finish matches most standard kit hardware. Wipes clean, but shows fingerprints and can pit if stored damp.

Detail 04

Tom hoop

Holds the head down against the bearing edge. Tension rods pass through it into the lugs on the shell.

Final check

Know before you order

  1. 01Count your tom's lugs before ordering — 6 versus 8 is the common mistake
  2. 02Tension rods and washers are not included
  3. 03One hoop only; a tom needs two for batter and resonant sides

Product questions

Before you decide

Straight answers to the questions shoppers most often ask about this product.

01Will this fit my 10-inch tom?

Only if the drum uses 6 lugs per side. Count the lug casings on the shell. If there are 8, this hoop will not line up.

02Does this come with tension rods?

No. This is the hoop alone. You will need six tension rods for it, plus washers if your old ones are worn.

03Is this for the top or bottom of the drum?

Either. A 10-inch 6-lug tom uses the same hoop on batter and resonant sides.

04Do I need to change my drum head too?

Not unless the head is damaged. You can pull the old hoop off, leave the head in place, and drop the new hoop on.