Detail 01
Ball joint
Angle adjusts freely in any direction rather than on one hinge, so you can reach positions a single-axis tilter cannot.
Product detailSKU #1273887992906
GibraltarBall Arm with 7/8" Post
Independent shopping perspective
The Korena take
A ball-joint arm with a 7/8 in. post for angling a cymbal or accessory off a rack or stand. For drummers fine-tuning mount positions.
Strong match
Who this is for
- Angling a cymbal into reach over a crowded rack
- Mounting accessories at an odd angle a straight arm cannot hit
- Replacing a fixed arm that will not tilt far enough
Consider the trade-offs
When to look elsewhere
- Mounts that do not accept a 7/8 in. post
- Drummers who need the clamp that grips the rack tube
- Positions where a rigid straight arm already works fine
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
7/8 in. post
The post end drops into a 7/8 in. receiver. Check what your clamp or stand accepts before ordering.
Detail 03
Arm plus post design
This is the extension between a clamp and a mount. It attaches to hardware you already have on both ends.
Detail 04
Gibraltar hardware
Uses common drum hardware sizing, so 7/8 in. receivers on other brands frequently accept it.
Detail 05
$37.99 price
Costs more than a fixed arm. The ball joint is what you are paying for, so skip it if a straight arm reaches.
Final check
Know before you order
- 01Confirm your receiver takes a 7/8 in. post before ordering.
- 02You still need a clamp or stand to hold the post.
- 03Tighten the ball joint fully. Heavy cymbals drift on a loose joint.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What does the post go into?
A 7/8 in. receiver on a rack clamp, multi-clamp or stand. It is an extension, not a standalone mount.
02Can I put a cymbal directly on this?
You attach a cymbal tilter or mount to the arm. The tilter is not part of this item.
03Will it hold position under hard playing?
A ball joint holds when fully tightened. If a cymbal is mounted far out on the arm, leverage makes correct tightening more important.
04Does it fit other brands?
Any hardware with a 7/8 in. receiver should take the post. Measure your existing mount to be sure.
