Detail 01
Angle adjustment
Lets a leg or arm sit off vertical, so you can reach over a tom or clear a kick pedal.
Product detailSKU #1273887993137
GibraltarAngle Leg Clamp
Independent shopping perspective
The Korena take
A clamp for setting a stand or boom leg at an angle. Useful when standard vertical placement will not fit your kit.
Strong match
Who this is for
- Angling a cymbal arm around a crowded rack setup
- Repairing a stand whose original leg clamp stripped
- Mounting hardware at an offset on a tight stage footprint
Consider the trade-offs
When to look elsewhere
- Anyone needing a full stand — this is a single clamp only
- Heavy ride cymbals where a dedicated boom stand is more stable
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Clamp, not a mount with an arm
You supply the tube or leg it grips. Nothing to hold a cymbal without additional hardware.
Detail 03
Memory of position depends on tightening
An angled load puts more leverage on the clamp, so torque it fully or it will creep during a set.
Detail 04
Gibraltar hardware sizing
Built around common drum hardware tube diameters, so it mates with most standard stands and racks.
Final check
Know before you order
- 01Measure your tube diameter before ordering — clamps are size specific
- 02No cymbal arm, tube or stand included
- 03Angled loads need the base weighted or the stand can tip
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What tube size does this fit?
It is built for standard drum hardware tubing. Measure the outside diameter of the leg or arm you plan to clamp and confirm it matches before buying.
02Can I use this to add a cymbal to my kit?
Only with a separate arm or tube, which is not included. The clamp holds hardware at an angle; it does not carry a cymbal on its own.
03Will it hold under hard playing?
Tighten it fully. Angled mounting adds leverage, so a clamp that is merely snug will slowly rotate over a long set.
04Is this for repairing a stand or adding to one?
Both. It works as a replacement for a stripped leg clamp and as a way to angle hardware in a setup where vertical placement does not fit.
