Detail 01
Digital-to-analogue conversion up to 96 kHz
Supports monitoring from the unit’s two-channel Dante receiver on headphones or loudspeakers.
Product detailSKU #1500000031887
FocusriteRedNet AM2 Headphone Amplifier
metalthrashpopcountry
1/4
Independent shopping perspective
The Korena take
RedNet AM2 brings Dante-network audio to a compact local monitoring point, with separate headphone and balanced line outputs. Use its front-panel TRS jack for headphones or send the same network source to loudspeaker monitoring through the rear XLR connections. Independent large level controls keep headphone and line volume easy to manage; the line section also has mute with an LED. Locking etherCON ports allow network connection and daisy chaining, while PoE or the included DC supply powers the unit.
Strong match
Who this is for
- Placing headphone and loudspeaker monitoring where a Dante network signal is needed
- Controlling headphone and line-monitor levels independently at a compact monitoring position
- Daisy chaining additional network devices from the two locking etherCON connections
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Maximum output: +21.5 dBu
The headphone output is designed to deliver significant power and drive high- or low-impedance headphones.
Detail 03
Frequency response: 20 Hz–20 kHz, ±0.1 dB
Covers the stated audible-frequency range for monitoring.
Detail 04
118 dB A-weighted dynamic range
Describes the stated separation between low-level and maximum-level signal handling.
Final check
Know before you order
- 01Plan to connect it to a Dante network.
- 02Choose PoE or use the included rear-panel DC power supply.
- 03The headphone connection is a front-panel 1/4-inch TRS socket; line outputs use rear male XLR connectors.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Can RedNet AM2 monitor through headphones and loudspeakers?
Yes. It has a front-panel 1/4-inch TRS headphone output and two rear balanced XLR line outputs for loudspeaker monitoring.
02Are headphone and line levels controlled separately?
Yes. Separate large controls set headphone and line output levels; the line output also has a mute button and LED.
03How is it powered?
It can run from Power over Ethernet or the rear barrel connector. A DC power supply is included.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsSound
- Frequency Response
- 20Hz–20kHz ± 0.1dB
1 detailsBody & build
- Color
- Red
1 detailsConnections & power
- Max Output
- +21.5dBu; 0dBFS input, R=600 Ohm
4 detailsOther
- Crosstalk
- -95dB; -20dBFS input, 20Hz–20kHz
- Signal to Noise Ratio
- 118dB "A"-weighted; 20Hz_20kHz, R=600 Ohm
- Dynamic Range
- 118dB "A"-weighted (-60dBFS method)
- Thd N
- 0.001% (-100dB) unweighted; -1dBFS input, 20Hz–22kHz
