Detail 01
TBX circuit
A stacked, dual-action tone control. Turning past center adds brightness rather than only rolling treble off.

Independent shopping perspective
Replacement tone control for Fender-style guitars with an expanded sweep. For players who want more range from the tone knob than a standard pot gives.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
A stacked, dual-action tone control. Turning past center adds brightness rather than only rolling treble off.
Detail 02
The knob clicks at the neutral position, so you can find flat by feel without looking down mid-song.
Detail 03
Designed around Fender pickup and pot values. Behavior on humbuckers or other pickup types will differ from the intent.
Detail 04
This replaces the existing tone pot in the harness. You are removing wiring and reflowing joints inside the control cavity.
Detail 05
The part is cheap. If you pay a tech to install it, labor will cost more than the control.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
If you can solder and read a wiring diagram, yes. It replaces the existing tone pot. Budget an hour and work carefully in the cavity.
Not necessarily. The stacked design uses a different shaft arrangement than a single tone pot. Check the shaft type before assuming your knob transfers over.
It is built for Fender-style single-coil circuits, which covers Tele wiring. Confirm your cavity has room for the taller stacked pot.
Below center it works like a conventional tone control, rolling off highs. Above center it opens the top end past where a standard pot sits.