Detail 01
Reverse dot
The reinforcement patch is on the underside, so the top stays a plain coated surface for brushes and consistent stick feel.
Product detailSKU #1316478164987
EvansPower Center Reverse Dot Coated Drum head - 10 in.
1/3
Independent shopping perspective
The Korena take
A 10-inch coated snare head with a reinforced center dot on the underside, built for hard hitters who wear out standard heads.
Strong match
Who this is for
- 10-inch piccolo or auxiliary snares taking heavy hits
- Rock and metal players who break heads often
- Drummers wanting more attack and less ring
Consider the trade-offs
When to look elsewhere
- Jazz or brush players needing a fully open head
- Drummers who want maximum sustain and sensitivity
- Any drum that is not 10 inches
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Coated finish
Textured white surface. Warms the tone slightly, cuts high overtones, and lets brushes actually make a sound.
Detail 03
Center dot reinforcement
Adds mass and durability where the stick lands most, boosting attack and extending head life under heavy playing.
Detail 04
10-inch diameter
Sized for the head, not the shell. Fits a 10-inch snare or tom, typically a piccolo or auxiliary drum.
Detail 05
Power Center design
Focuses the sound toward attack and body rather than long ring, so the drum cuts through a loud mix.
Final check
Know before you order
- 01Measure your drum head diameter before ordering, 10 inch is exact
- 02Batter head only, you still need a resonant head underneath
- 03Plan on retuning; a new head stretches for the first few sessions
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01What does reverse dot mean?
The reinforcing dot is applied to the bottom of the head instead of the top. You get the durability and attack without a dot under your stick or brushes.
02Is this a batter head or a resonant head?
Batter. It goes on the top, playing side of the drum. The thin resonant head underneath is separate.
03Will this fit a 10-inch tom?
Yes. It is cut for a 10-inch drum. It is voiced for snare duty but works on a 10-inch tom if you want a drier, punchier sound.
04Can I use brushes on it?
Yes. The coating is on the top surface and the dot is underneath, so brushes sweep across a normal coated head.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
1 detailsBody & build
- Color
- 10 in.
