Detail 01
30 in.
One of the larger marching bass sizes, carried by the bottom voice in a bass line. Must match your shell exactly.

Independent shopping perspective
30-inch white marching bass drum head. For corps and marching band players replacing a head on a full-size bass drum.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
One of the larger marching bass sizes, carried by the bottom voice in a bass line. Must match your shell exactly.
Detail 02
Rounder low end rather than a sharp crack. Reads as pitch in the ensemble instead of a click.
Detail 03
Built for mallet strikes outdoors over a full season, which is harder wear than a kit head sees.
Detail 04
Voicing comes from tuning tension and any muffling you add, not from a fixed built-in damping ring.
Detail 05
Mallets sink in slightly rather than bouncing off, which shapes the note and eases hand shock.
Detail 06
Standard marching look, and smooth rather than coated, so mallets glide without grabbing.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
No. Kit bass drums typically run 18 to 24 inches. This is a 30 inch marching size and will not fit a standard kick.
One. A marching bass drum has a head on each side, so replacing both means ordering two.
Yes. Marching bass drums use the same head on both sides, and matching them keeps the tone consistent.
Warm, with a rounder low end than a bright attack. How much attack and sustain you get depends on your tuning and muffling.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.