Detail 01
14 in.
Head size matches the drum's shell diameter, not the rim. Measure the shell edge to edge before ordering.

Independent shopping perspective
A 14-inch frosted single-ply head for marching or concert tenor drums. For players replacing a worn head on a budget tenor.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Head size matches the drum's shell diameter, not the rim. Measure the shell edge to edge before ordering.
Detail 02
Frosted film scatters some high overtones, so attack reads a little softer and darker than a clear head.
Detail 03
Built for tenor drums specifically. Tension and feel are tuned for the higher pitches tenors sit at.
Detail 04
You get one head. A full tenor set needs one per drum, so count your drums first.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It's built as a tenor head. The 14-inch diameter is the same, but the film is voiced for tenor tuning and attack, not kit tom response.
It's a tenor batter head — the one you strike. Marching tenors are typically single-headed, so this is the only head on the drum.
The frosted coating on the film knocks down some of the highest overtones. Attack is a touch softer and the tone slightly warmer than a clear head.
Yes. You'll pull the tension rods to remove the old head and retension evenly on the new one. A key isn't included.