Detail 01
Batter head
Goes on top, the side you strike. The bottom of the snare needs a separate snare-side head.

Independent shopping perspective
Coated batter head for a 14-inch snare with built-in overtone control. For players who want a dry, focused crack instead of ring.


Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Goes on top, the side you strike. The bottom of the snare needs a separate snare-side head.
Detail 02
Textured surface gives brushes something to grab and softens stick attack slightly compared to clear film.
Detail 03
Perimeter vent holes let overtones escape, shortening the ring without adding tape or gels on top.
Detail 04
Heavier-duty film. Takes hard hitting and rimshots better, at the cost of some sensitivity to quiet strokes.
Detail 05
Matches a standard 14-inch snare shell. Measure the shell, not the hoop, before ordering.
Detail 06
Comes pre-controlled, so you start dry. You cannot dial the muffling back out if you want more ring.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Usually not. The vents and damping are built in. Add muffling only if your specific drum still rings more than you want.
The coating gives brushes a proper surface to sweep. It is a heavier head, so it responds better to firm strokes than to whisper-quiet work.
It fits any 14-inch drum, including a 14-inch floor tom, but the built-in damping will shorten the tom's sustain noticeably.
Top. This is the batter head you play on. The bottom takes a thin snare-side head under the wires.