Detail 01
Bass drum muffler
Sits inside the shell against the head, shortening sustain and tightening the low end into a defined thump.
Product detailSKU #1274034479647
EvansEQ Pad Bass Drum Muffler
1/3
Independent shopping perspective
The Korena take
A foam muffling pad for inside a bass drum. For drummers who want a shorter, tighter kick without taping pillows or blankets in place.
Strong match
Who this is for
- Taming a boomy kick in a small room
- Studio recording where long kick sustain muddies the mix
- Drummers who want repeatable muffling gig to gig
Consider the trade-offs
When to look elsewhere
- Players chasing an open, resonant jazz kick
- Toms or snares — this is bass drum only
- Anyone whose kick already sounds tight enough
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Pad, not a pillow
Holds its position and shape, so the amount of damping stays the same each time you set up.
Detail 03
Adjustable contact
How much of the pad touches the head sets how dead the kick gets. Less contact keeps more tone.
Detail 04
Goes inside the drum
You need to remove a head or reach through the port hole to place it.
Final check
Know before you order
- 01No heads included — this only damps the head you already have
- 02Placement matters; contact against the batter head damps more than against the reso
- 03Removing a bass drum head means a retune afterward
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Do I need a port hole to install it?
A port hole makes it far easier. Without one you have to take a head off to place the pad.
02Will this work on toms?
No. It is sized and shaped for a bass drum interior.
03Can I still get some sustain?
Yes. Reduce how much of the pad touches the head and the drum keeps more of its ring.
04Does this replace a pillow or blanket?
Yes. It does the same job but stays put and gives the same result every setup.
