Detail 01
Model-specific to the 7002PX
Fit is tied to one stand. Other DW hi-hat models use different linkage geometry and will not accept it.
Product detailSKU #1274115037988
DWSP-972 Linkage Assembly for 7002PX
Independent shopping perspective
The Korena take
Replacement linkage assembly for the DW 7002PX hi-hat stand. Buy it if that specific stand's linkage is bent, worn, or missing.
Strong match
Who this is for
- Repairing a 7002PX hi-hat stand instead of replacing the whole stand
- Drummers keeping a spare part in the hardware bag
- Techs maintaining a kit that travels and takes knocks
Consider the trade-offs
When to look elsewhere
- Any hi-hat stand other than the DW 7002PX
- Drummers wanting to change feel — this restores stock action, not improve it
- Anyone unsure which part actually failed on their stand
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Linkage assembly
This is the arm that transfers pedal motion to the pull rod. A bent one causes lost travel and sloppy chick.
Detail 03
Under $30
Cheap enough that replacing a damaged linkage beats buying a new stand or living with bad response.
Detail 04
Assembly, not a single part
Comes as a unit, so you swap the whole linkage rather than trying to source individual pins or joints.
Final check
Know before you order
- 01Confirm your stand is a 7002PX — check the model stamp before ordering
- 02Basic hand tools and a few minutes of disassembly are needed
- 03Only the linkage is included — no pull rod, clutch, or springs
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this fit my other DW hi-hat stand?
It's made for the 7002PX. Other DW hi-hat stands use different linkage designs, so treat it as fitting that model only.
02Is this hard to install?
It's a bolt-on hardware swap. Remove the damaged linkage, fit the new one, retighten. No special tools or drum-tech experience required.
03How do I know the linkage is what's broken?
Symptoms are lost pedal travel, wobble, or the hats not closing fully while the spring and rod look fine. Inspect for bending at the joints.
04Does it come with hardware to mount it?
It ships as the linkage assembly itself. Reuse the fasteners from your stand unless they're stripped or missing.
