Detail 01
Remote cable drive
Foot pedal and cymbal stand are separate units connected by cable, so placement is no longer tied to the pedal.
Product detailSKU #1274115037899
DW9000 Series Remote Hi-Hat 6 ft.
1/2
Independent shopping perspective
The Korena take
Cable-driven remote hi-hat with a 6 ft. line, so the hats mount anywhere on the kit while the pedal stays under your foot. For crowded or unconventional setups.
Strong match
Who this is for
- Left-side hats over a double pedal, where a stand won't fit
- Auxiliary hats placed above toms or on the far side
- Large kits where the main hi-hat position is already occupied
Consider the trade-offs
When to look elsewhere
- A standard four-piece setup with room for a normal hi-hat stand
- Drummers who want the most direct pedal feel possible
- Anyone on a tight budget — a conventional stand costs far less
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
6 ft. cable length
Enough reach to cross a full kit, including placing hats on the opposite side from the pedal.
Detail 03
9000 Series
DW's top hardware tier — heavier castings and more adjustment points than their entry-level lines.
Detail 04
Cable actuation vs. direct rod
Adds slight lag and friction compared to a standard stand; tight cable routing matters for response.
Detail 05
Two-piece design
Pedal and cymbal post both need floor or rack space, and both need to be secured against creep.
Final check
Know before you order
- 01Hi-hat cymbals are not included — you supply the pair
- 02Route the cable in wide, gentle curves; tight bends kill the feel
- 03Check clearance around your double pedal before choosing a pedal position
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Do I still need a regular hi-hat stand?
No. This replaces it. The cymbal post holds the hats and the separate pedal drives them by cable.
02Does it feel like a normal hi-hat?
Close, but not identical. Cable drive adds a small amount of drag. Clean cable routing with wide curves keeps it responsive.
03Can I mount the cymbal side on a rack?
The cymbal section is a standalone post. Rack mounting depends on your rack's clamps and the post diameter.
04Will it work with any hi-hat cymbals?
Yes, standard hi-hat pairs fit the clutch and bottom cup. Heavier hats need more pedal effort through the cable.
