Detail 01
Remote controlled
The chassis stays in the rack near the cable runs while you switch from the desk, hands on the console.
Product detailSKU #1318627584023
Dangerous MusicMONITOR ST Remote-Controlled Source and Speaker Switcher
Independent shopping perspective
The Korena take
Remote-controlled switcher for studio monitoring: picks between playback sources and between speaker pairs. For rooms running more than one of either.
Strong match
Who this is for
- Studios with two or more monitor pairs to A/B
- Comparing DAW, reference, and other playback sources without repatching
- Keeping the box racked and the control at the desk
Consider the trade-offs
When to look elsewhere
- One source, one speaker pair — a simple level control does more
- Home setups where a four-figure routing box outweighs the rest
- Anyone wanting conversion or computer connection in the same box
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Source switching
Several playback devices feed one monitor path, so changing what you listen to is a button, not a cable swap.
Detail 03
Speaker switching
Jump between monitor pairs mid-mix to hear how the balance holds up on different cabinets.
Detail 04
Switcher, not an interface
It sits after your outputs and routes signal to monitors. Conversion still happens upstream in your existing rig.
Detail 05
$2,749 tier
Pro-room pricing. You are paying for clean switching in the monitor path, which is the one signal you trust for decisions.
Final check
Know before you order
- 01Count your sources and monitor pairs first — capacity decides whether it fits
- 02Every source and speaker pair needs its own cable run; budget for them
- 03Check the remote reaches from rack position to your listening seat
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01what does a monitor switcher do
It sits in your monitoring path and lets you choose which playback source you hear and which pair of speakers it goes to, without unplugging anything.
02can I compare two sets of monitors with this
Yes. Speaker switching is the point — you wire multiple monitor pairs in and switch between them to check how a mix translates.
03does this replace my audio interface
No. It handles source and speaker switching only. Your interface still does conversion and connects to the computer.
04where does it go in the signal chain
After the outputs of your playback sources, before your monitors. It is the last analog stop before the speakers.
