Detail 01
6 in. length
Enough to bridge two pedals sitting directly next to each other. Any gap wider than that and the cable will not reach.

Independent shopping perspective
Three 6-inch right-angle patch cables for connecting pedals on a board. For anyone assembling or tightening up a small pedalboard.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Enough to bridge two pedals sitting directly next to each other. Any gap wider than that and the cable will not reach.
Detail 02
The plug turns immediately at the jack, so pedals sit closer together and nothing sticks out past the board edge.
Detail 03
Three cables chain four pedals in a row. Count your pedals before ordering, since gaps need one cable each.
Detail 04
Built for the short hops between pedals. It will not reach from guitar to amp.
Detail 05
Disappears against a dark pedalboard, which makes it harder to spot a specific cable when troubleshooting.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Four pedals in a single chain. Each cable bridges one gap, so the number of cables you need is always one fewer than the number of pedals.
No. At six inches these only reach between adjacent pedals. You need a full-length instrument cable for guitar to amp.
They fit standard side-mounted 1/4 inch jacks. Pedals with jacks on the top face or set very close together can make the angled plug awkward.
Usually not. Jumping from the end of one row to the start of another needs a longer patch cable, typically 12 inches or more.
Reference
The complete catalog record, organized around the decisions musicians make when comparing gear.