Detail 01
Stereo outputs
Two outputs spread the reverb tails wide. Into one amp you lose most of that width.
Product detailSKU #1315669858958
BehringerDR600 Digital Stereo Reverb Guitar Effects Pedal
dynamicambientpost rockshoegaze
1/8
Independent shopping perspective
The Korena take
Digital stereo reverb pedal at an entry price. For players who want ambient wash on a tight budget and can live with plastic housing.
Strong match
Who this is for
- First reverb on a starter board with limited spend
- Ambient, post-rock and shoegaze washes over clean tones
- Adding stereo spread when running two amps
Consider the trade-offs
When to look elsewhere
- Gigging players who need a road-proof metal enclosure
- Anyone chasing high-end spring or plate character
- Boards with no room for a 9V supply per pedal
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Digital reverb
Tails stay clean and consistent rather than reacting to pick attack the way spring tanks do.
Detail 03
Behringer plastic housing
Light and cheap, but the footswitch and jacks take stomping less well than cast metal.
Detail 04
Under $45 price
Buys reverb sounds, not build quality. Treat it as a board filler or bedroom pedal.
Detail 05
Touch-responsive voicing
Reverb level tracks how hard you play, so light passages stay dry and loud ones bloom.
Final check
Know before you order
- 01No power supply included. Plan on a 9V battery or a spare board output.
- 02Two cables needed for stereo, plus a second amp or interface input.
- 03Place it late in the chain, after drive and before delay.
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Does it run on a battery?
Yes, it takes a 9V battery. Most players use a standard 9V pedal supply instead, since reverb pedals drain batteries faster than simple boosts.
02Is it true bypass?
It uses a buffered digital signal path. With a long cable run that buffer actually helps, but the reverb tails cut off when you switch it off.
03Can I use it in an amp effects loop?
Yes, and that is usually the better spot. Reverb in front of a driven amp gets muddy; in the loop it stays clear.
04Will it work for bass or keys?
It will pass the signal, but it is voiced for guitar. Low end can wash out. Blend the reverb back if you use it that way.
Reference
Full specifications
The complete catalog record, organized around the decisions musicians make when comparing gear.
6 detailsOther
- Category Source
- detail
- Tier
- new
- Korena Special
- false
- Source Id
- site51315669858958
- Dimensions (WxHxD)
- 2.76" (7 cm) x 2.13" (5.4 cm) x 4.84" (12.3 cm)
- Weight
- 0.73 lb. (0.33 kg)
Complete your setup
Worth comparing
1 of 12
