Detail 01
Fits the DJX400 and DX626 only
Fader bodies and pin layouts aren't standardized between mixers, so a part from another model will not drop in.
Product detailSKU #1315669859981
BehringerCFM-1 Replacement Crossfader for DJX400 and DX626
1/3
Independent shopping perspective
The Korena take
A replacement crossfader for the DJX400 and DX626. Buy it when the fader gets scratchy or drops out, not as a performance upgrade.
Strong match
Who this is for
- Reviving a DJX400 or DX626 with a worn crossfader
- Keeping a spare for a mixer you gig with
- Cheap repair on a mixer that's otherwise still working
Consider the trade-offs
When to look elsewhere
- Any other mixer — the fit is model-specific
- Anyone wanting faster cut-in or a lighter feel
- Someone unwilling to open the mixer and work inside it
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Crossfader, not a channel fader
This is the horizontal blend fader across the bottom. The vertical channel faders are a different part number.
Detail 03
Replacement, not an upgrade fader
Feel, throw and cut-in point match the original. Nothing about your scratching or blending gets easier.
Detail 04
$6.29
Cheap enough to buy two — one to fit now, one in the bag for the night it fails again.
Detail 05
It's a wear part
Faders die from dust and spilled drinks, not age. Replacing one is routine maintenance, not a repair job.
Final check
Know before you order
- 01Check the model number on the back panel first — similar Behringer mixers use different faders
- 02You'll need to open the unit; expect screws, a knob cap and internal wiring
- 03Try contact cleaner first — a scratchy fader is often just dirty
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Will this fit my other Behringer mixer?
Only the DJX400 and DX626. Other models use different fader assemblies even when the panel layout looks similar.
02Do I have to solder it in?
Depends how your unit is wired — some faders sit on a connector, others are soldered to the board. Open it and look before ordering tools.
03Is this better than the fader that came with the mixer?
No. It's the stock part, so it performs the same way. If you want a lighter, faster fader, this isn't it.
04My crossfader cuts out at one end — will this fix it?
If cleaning doesn't help, yes. Dead spots and dropouts at the travel ends are the normal failure mode for a worn fader.
