Detail 01
Super-thin
Adds very little mass, so it changes tone less than a thick patch while still taking the beater hits.

Independent shopping perspective
A thin adhesive patch that protects a bass drum head where two beaters strike. For double pedal players wearing through heads at the impact points.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Adds very little mass, so it changes tone less than a thick patch while still taking the beater hits.
Detail 02
Covers two strike zones side by side, so both beaters land on protected film instead of bare head.
Detail 03
Sticks straight to the head with no hardware. Removal can leave residue, and it is not reusable.
Detail 04
This is protection only. A worn or torn bass drum head still needs replacing.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
Slightly. It adds a bit more attack and click at the beater spot. Because it is thin, the change is small compared to thick patches.
You can, but it is shaped for two beaters, so half of it goes unused. A single patch is a better fit.
Yes. It is most useful with hard plastic or wood beaters, which chew through bare heads fastest.
Treat it as one-time. Pulling it up stretches the patch and weakens the adhesive, and it may leave residue behind.