Detail 01
20 in.
Matches a 20-inch shell diameter, not the hoop. Measure across the bare shell before ordering.
Product detailSKU #1274115040141
AquarianSuper-kick III Bass Drumhead 20 in
1/2
Independent shopping perspective
The Korena take
A 20-inch bass drum batter head from Aquarian's kick-specific Super-Kick line. For drummers replacing a worn kick head on a 20-inch bass drum.
Strong match
Who this is for
- Replacing the beater-side head on a 20-inch bass drum
- Kits where the kick sounds ringy and needs focus
- Players who want a kick head without adding aftermarket muffling
Consider the trade-offs
When to look elsewhere
- 22-inch or 18-inch bass drums — head sizes are not adjustable
- Anyone needing a front/resonant head with a port hole
- Toms or snare, which take their own sizes and head types
What matters in use
The specifications, translated
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 02
Bass drum head
Built to take beater impact in one spot, so it is thicker and more focused than a tom head.
Detail 03
Batter side
Goes on the side the pedal hits. The front head stays whatever you already have.
Detail 04
Super-Kick series
Aquarian's dedicated kick line, tuned toward controlled low end rather than long open sustain.
Detail 05
Single head, $66.99
Kick heads cost more than tom heads because of size and construction, but you replace them far less often.
Final check
Know before you order
- 01One head only — no front head, pillow, beater or tuning key included
- 02Measure the shell diameter, not the hoop, or the head will not seat
- 03Keep the old hoop and claws; you are only swapping the film
Product questions
Before you decide
Straight answers to the questions shoppers most often ask about this product.
01Which side does this go on?
The batter side — the side your pedal beater strikes. Your existing front head stays on.
02Will it fit a 22 inch kick?
No. Drumheads are sized to the shell, so a 20-inch head only fits a 20-inch bass drum.
03Do I still need a pillow or muffling inside?
Try it without first. This is a kick-specific head, so start bare and only add internal damping if it still rings longer than you want.
04What tools do I need to change it?
Just a drum key. Loosen the tension rods evenly, lift the hoop off, swap the head, then tension in a star pattern.
