Detail 01
Two-ply construction
Two film layers absorb overtones and take harder hits than a single-ply head. Less ring, more thud.

Independent shopping perspective
An 18-inch two-ply tom head with a center dot for extra attack and shorter sustain. For drummers who want a controlled floor tom.

Strong match
Consider the trade-offs
What matters in use
Catalog numbers tell only part of the story. These are the details most likely to change how this product feels, sounds, or fits into a setup.
Detail 01
Two film layers absorb overtones and take harder hits than a single-ply head. Less ring, more thud.
Detail 02
Extra film patch at the strike zone adds attack, cuts sustain further, and protects the spot sticks hit.
Detail 03
Fits an 18-inch drum measured shell-edge to shell-edge, not by the hoop. Common floor tom size.
Detail 04
This is the top playing head. The bottom resonant head is separate and stays thinner for tone.
Detail 05
Aquarian heads use a bonded hoop-to-film joint, so the film is less likely to pull out under high tension.
Final check
Product questions
Straight answers to the questions shoppers most often ask about this product.
It's a batter head — the one you strike. It's built thick with a reinforcing dot, which is wrong for the resonant side.
Yes, if the shell measures 18 inches across. Measure the shell itself, since hoop measurements run larger.
It's built and tagged as a tom head. An 18-inch bass drum batter is a different, heavier design.
Noticeably. It shortens sustain, tightens the low end, and makes the initial stick attack more defined than a plain two-ply head.